Complete Water Solutions provides a comprehensive Preventative Maintenance Program when it comes to Industrial Reverse Osmosis Systems. We even provide documentation and services for audits both internally and externally. Below is an example of what we do while onsite.
What will we do?
Building engineer check:
We first check with the building engineer to ask about the system and its performance. We inspect the equipment maintenance log, if available.
Water quality check:
Water is tested for hardness, chlorine leakage, Iron, reverse osmosis quality, EDI / CEDI Quality.
Exterior system check:
Piping, valves and tanks will be inspected for leaks, corrosion or exterior damage.
A complete report is issued after each inspection, which includes all pertinent data.
Valve operation check on Softeners:
Flow patterns for regeneration and service cycles are checked for proper operation. Each cycle will be started for an abbreviated period:
- Service cycle
- Backwash cycle
- Brine cycle
- Rinse cycle
- Flush cycle
- Manual operation of each cycle to check the pilot spool
- Cam gear and pilot strainer are inspected
- Pressure tubing to valves is inspected.
- System is checked for leaking to drain
Brine system check:
- Brine tank and brine level in the tank are inspected
- Brine valve is inspected
- Brine rinse cycle is timed and checked for depressurization
- Brine draw and rate is observed
Valve operation check on Media Filtration:
Flow patterns for backwashing and service cycles are checked for proper operation. Each cycle will be started for an abbreviated period:
- Service Cycle
- Backwash Cycle
Controls are observed for proper operation and programming. Adjustments are made as needed. Electronic controls are manually stepped through operations and reviewed for proper programming. Re-writing of any program is not included.
- A complete report is issued after each inspection, which includes all pertinent data.
- Pump & Motor Check
- Membrane / Prefilter Check
- Pressures are regulated, and adjusted for best possible quality water.
The Electronic Deionization System is checked for quality, resistivity output, and electrical consumption. All wiring and water connections are checked. Adjustments are made for best quality water.
Calibration Of Probes & Monitors – pH, Conductivity, Resistivity, Hardness, Chlorine, ORP
Training on the sequence of operation of the existing system shall be provided for new or existing personnel upon request.
Industrial Reverse Osmosis System Preventative Maintenance contracts can include all parts, service parts, membranes, pre filters. We even provide contracts up to 5 years to include all maintenance items.