Manganese Greensand Filter with 315 Gallons per Minute (GPM) Continuous Service Flow Rate

Product Specs

SKUGS-120
Shipping Weight35,000 lb
Key FeaturesCWS MX-II electronic system controller
Timer initiated backwash cycle
Water activated diaphragm style control valves
NEMA-4X electrical enclosures (FRP)
Inlet/Outlet pressure gauges and sampling valves
Factory Hydro-tested at 100 psig
Inlet Operating Pressure30 to 100 psig
AC Voltage120 V
Electrical Phase1
Frequency60 Hz
Operating Temperature35 to 110 ºF
Available OptionsSkid mounted, pre-piped, pre-wired systems
Differential pressure switch backwash cycle
Multiple tank parallel configurations
ASME code stamped resin tanks
Allen-Bradley PLC systems
PVC or CPVC exterior face-piping (PVC standard for filters with 6” service)
Copper or Stainless steel exterior face-piping
Stainless steel internal distributor piping
Seismic zone rated systems
Butterfly control valves (air operated; standard for filters with 6” service)
Air-scour backwash system
Steam / hot water sanitizable carbon filters
Alternate filter media (Birm, Filter-AG, Calcite)
Filter TypeManganese Greensand
Continuous Service Flow Rates315 gpm
Peak Service Flow Rates630 gpm
Back Wash Flow Rates800 gpm
Service Pipe Size6 in
Drain Pipe Size6 in
Media Volume200 ft³
Tank Diameter120 in
Tank Length60 in
Overall Length121 in
Overall Width146 in
Overall Height115 in
NotesAt expected pressure loss not exceeding 5 psig, based on a clean filter bedShipping weights are estimate only. Weights include resin and support gravel, which are added to the tanks after installation.Dimensions are estimate only. Actual dimensions may vary based on job-site space limits and piping layout. Allow a minimum of 24” above height dimension for resin loading. Use of ASME rated tanks may add up to 12” of tank height. Consult factory for dimensions on skid mounted systems.